Handgun Forum banner
1 - 5 of 5 Posts

·
Super Moderator
Joined
·
12,472 Posts
Discussion Starter · #1 ·
A while back on the other Beretta forum, someone posted some pics of the PX4 frame - they were getting some wear on the frame where the bullet loads into the barrel. Anyone else getting that?

No matter what the gun, even if I really want it, I always wait a while for the bugs to wear out.
 

·
Registered
Joined
·
17 Posts
I am not seeing any feedramp wear at all. However, I've only put 3 rounds of hollow points through it thus far (the other 17 occupy the full magazine.) FMJ's of nearly every typical brand have been fed through it though... no issues.
 

·
Registered
Joined
·
4 Posts
**note** this is not my gun, however I did have the burr on the feed ramp that is in the pic#2
*sorry for the small type in the picture captions it was a quick paint program edit*

I noticed my burr after 165 rounds when I was cleaning it. this did not cause any problems for the gun. I did take a knife and cleaned it up.

 
1 - 5 of 5 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top