Handgun Forum banner

P238 Safety Problem

2K views 0 replies 1 participant last post by  gs46 
#1 ·
Had a bit of trouble with my P238 safety....it would not engage (saftey position) if the hammer was in the cocked position. If you pushed the hammer back a hair farther then it would engage. The problem accured after about 150 rounds. After inspection I found it needed to be honed or just touched with a file on the beveled side of the safety arm to clear the hammer when the hammer was in the cocked position. The safety actually, when engaged, rotates the hammer back a tiny bit more and lifts it off the seer....works fine again!:rolleyes:
 
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top