Results 1 to 2 of 2
  1. 02-17-2011, 05:46 AM #1
    Ruger71's Avatar
    Ruger71
    Ruger71 is offline Member
    Join Date
    Jan 2007
    Location
    Mssouri
    Posts
    122

    Big Chambers, Small Throats-45 Colt Blackhawk

    I know I can ream the throats, but is there any repair short of a new cylinder that would allow tighter tolerances in the chambers? It's a little hard on brass stretching so much and I am not getting a good seal in the cylinder. Is this something Ruger might take care of? It came from the factory that way, but that was 5 years ago.
    Reply With Quote Reply With Quote
  2. Ads
  3. 02-25-2011, 03:38 PM #2
    texagun's Avatar
    texagun
    texagun is offline Junior Member
    Join Date
    May 2007
    Location
    North Texas
    Posts
    64
    If the chamber diameters are out of spec, Ruger should make a new cylinder for your gun. How big are they?
    Reply With Quote Reply With Quote
« Previous Thread | Next Thread »

Ads

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  

Forum Rules

Search tags for this page

.45 small colt

,

45 chamber throats

,

blackhawk 45 chamber throats

,
blackhawk chamber throat problems
,
cylinder throat reamer
,

cylinder throats blackhawk .45 colt

,
how to ream chamber throat on ruger .45 colt cylinder
,

how to ream revolver cylinders

,
how to ream revolver throat
,
how to ream ruger 45 colt cylinders
,

ream 45 colt blackhawk

,

ream revolver chambers

,
reaming handgun cylinders
,

ruger .45 colt cylinder throats

,

ruger 45 colt chambers

,

ruger 45 colt cylinder problems

,
ruger blackhawk .45 colt chambers
,

ruger blackhawk throats

,
ruger forums 45 colt cylinder throats
,

small throats