Handgun Forum banner

P95DC Dissasembly Problem

4K views 5 replies 5 participants last post by  PiTRiFF 
#1 · (Edited)
I just purchased a P95DC used and decided to field strip it. After removing the slide stop the next step is to push forward and remove the entire slide assembly. The problem is that the slide will not come off. Im not sure if I am doing it wrong but I dont think I am. Has anyone else had a hard time with this
 
#5 ·
yea same as the P94 drop the mag lock the action open, reach in push down on the little black metal bar it should lock in the down position, pull the pin and the slide should come right off
 
#6 ·
I got it. There is a metal clip inside that is supposed to move freely. It was stuck do to being dirty. After removing the pin I pushed that down and out of the way and the slide came off just fine. The gun was filthy! I cleaned and oiled it and after that the problem went away.

thanks for the help.
 
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top