Handgun Forum banner

Issue with Truglo Tritium sights

703 views 0 replies 1 participant last post by  MarTay6 
#1 ·
My first post in this section... I just installed a set of Truglo sights (TG131MPT) on my S&W M&P Shield- and notice an issue. Around the edges of the sight pipes, both front and rear, I can see a dot of light that's distracting... it shows as a pinpoint dot of white light somewhere between the 5:00 to 7:00 position on the edge of the green. It is coming from ambient room lighting- and goes away if I cover up the top of the sight nearest my eye. In inside lighting, it is noticeable on all 3 dots, I took it outside and it was only visible on the front sight. It is highly distracting. Any thoughts??
I'm wondering if I seal the top with epoxy- as I've seen some comments doing (to prevent the tubes from coming out)- if that might block the light enough to eliminate that distracting dot?
Wes
 
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top