New member and new owner of "ANIB" (that's ALMOST New-in-Box) CW9. After the "hair" (as in hair trigger) slide release caused a 'premature slide closing' and chewed a serious hunk out of the inside of my "signal finger" (blood does adhere to stainless steel!), I discovered that previous backyard gunsmith had been fooling with the spring and apparently used an allen wrench, NOT a number 6 torx on the screw, chewing it out pretty badly. There was black 'swarf" from who knows where, trapped under the rear of the spring, so that it cannot swing/pivot (like my CW45 shows that it should) One mag has strong enough spring to push the catch into full engagement, (and two others - New) will almost do it The other, not. Any advice greatly welcome. I love the pistol, but knowing it's not 100% right eats at me. Any advice much appreciated. - John