You will have to find an aftermarket slide or have the factory slide refinished. Have the slide refinished will be the least expensive route. I did this on a Sig.

Before....




And after....

Read you can easily sand down the slide for the look you want.
http://passpigs.tripod.com/as/glock19s/index.html

Originally Posted by group17

Read you can easily sand down the slide for the look you want.
http://passpigs.tripod.com/as/glock19s/index.html

You better maintain that very well. I see rust in it's future without a protective coating. Glock slides are not SS.

Originally Posted by group17

Read you can easily sand down the slide for the look you want.

Yup, you can.

Then run it through a Glock torture test... and see how much rust it has!

Dosborn,
How did you go about refinishing the slide? Also how was the cost roughly? Thanks for the input.

Mike

Originally Posted by GO24JUNIOR

Dosborn,
How did you go about refinishing the slide? Also how was the cost roughly? Thanks for the input.

Mike

I think the total was around $125 after shipping. I had a company by the name of CCR to the work. They are very good at what they do.

I started a thread like this, but went to the extreme. Here is my thread.

+1 ccr.

I would recommend rockyourglock.com I have dealt with them a few times and they're service is great. They offer hard chrome plating for slides and its only 75 bucks. its a high quality finish too. they also have a variety of services specially designated for the glock. they're entire company is strictly for glocks.

They're the Glock Experts
http://www.rockyourglock.com/custom/...g/RBR-CHRM.htm

hope this helps

Caspian makes aftermarket slides for Glock in stainless.