Have a local machine shop make a handle for you, from bar stock. Let them work from the original.*
It will probably be less expensive than importing something.


*Another method would be to weld an extension onto the existing handle, have it shaped to your desires, and have it re-heat-treated. That, too, should be less expensive than importation.

Thank-you, Steve. I came across a thread from another forum where a guy did just that. What he did was even easier - he machined a knurled knob for the end only, and drilled and tapped a set screw into it. It slides over the original handle and tightens down. I suppose you could even tack a small weld onto the charging handle to make sure it stays put. I'll look into it. It is also my understanding that a charging handle that is too heavy may interfere with cycling.

Cannon