Handgun Forum banner

BRD strikes again

1K views 10 replies 8 participants last post by  john doe. 
#1 ·
My Sunday project, Troy free float rail, Troy flip front, Vortex flash hider and Magpul triggerguard added to the Bushy:

 
See less See more
1
#8 ·
Triggerguard took all of 5 minutes, you just have to be sure to back up the reciever with a wood block so you don't break off the tab on the reciever.

The quad rail is a two piece free float, 13" - so in this case you don't have to remove the front sight block, just dremel off the delta ring. But since it's 13" on a carbine gas system, I still modified the front sight block by dremeling off the sight tower and reshaping, then re-blueing.

The original flash hider was a b$%% to get off - I finally ended up dremeling away the crush washer to loosen it's grip. God bless the Dremel.

And in case anyone is interested, the vertical foregrip has a rather lo-tech mod, a bicycle grip slipped over it..

Hopefully I'll get to take her out sometime this week :smt067
 
#9 ·
AJ how could you? Now some poor kid in the neighborhood has only one handle bar grip. Ha! Ha! Just kidding. That is a AWESOME looking gun you built there.
Good luck with it and let us know how it shoots.
 
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top