PX4

A while back on the other Beretta forum, someone posted some pics of the PX4 frame - they were getting some wear on the frame where the bullet loads into the barrel. Anyone else getting that?

No matter what the gun, even if I really want it, I always wait a while for the bugs to wear out.

I am not seeing any feedramp wear at all. However, I've only put 3 rounds of hollow points through it thus far (the other 17 occupy the full magazine.) FMJ's of nearly every typical brand have been fed through it though... no issues.

Well, hopefully, it's just a limited issue, then...

**note** this is not my gun, however I did have the burr on the feed ramp that is in the pic#2
*sorry for the small type in the picture captions it was a quick paint program edit*

I noticed my burr after 165 rounds when I was cleaning it. this did not cause any problems for the gun. I did take a knife and cleaned it up.


http://www.imagestation.com/picture/...3/efeee16d.jpg

Yes, that is what I saw - something similiar on another website.